Anritsu ML2437A - HP-IB Support

HP-IB Support
C-18 PN: 10585-00001 Rev. P ML2437A/38A OM/PM
C-6 HP-IB Support
The following tables list HP-IB commands for the HP437B and HP438A power meters, and
which commands are supported in the Anritsu ML243xA power meter. Restrictions, if any,
are also listed. Commands that are not supported will be ignored.
HP437B Commands
Table C-18. HP437B Emulation Mode Commands
Mnemonic Action Supported? Restrictions
CL CAL 0 dBm Yes None
*CLS Clear Status Yes None
CS Clear status Yes None
CT0-CT9 Sensor data tables Yes None
DA Set all screen pixels Yes None
DC0 Duty cycle OFF Yes None
DC1 Duty cycle ON Yes None
DD Disable display Yes DISP OFF restrictions:
Screen and min/max
not updated, Relative
not active
DE Display enable Yes DISP ON. None.
DF Disable Display Yes see DD
DN Down arrow No Not supported
DU User message No Not supported
DY Duty cycle Yes None
EN Enter msg terminator Yes None
ERR? Error query No Not supported
*ESR? Read event reg Yes None
*ESE Set event enable reg Yes None
*ESE? Read event enable
reg
Yes None
ET0-ET9 Edit cal factor table Yes None
EX Exit Yes None
FA Auto average Yes None
FH Average hold Yes None
FM Manual average Yes None
FR Set frequency Yes Switch to frequency
cal factor source.
GT0 Ignore GET Yes None
GT1 TR1 on GET Yes None