HP438A Emulation Commands GPIB Operation
8-130 PN: 10585-00001 Rev. P ML2437A/38A OM/PM
SM (Status Message)
ST (Store setup)
Syntax: SM
Remarks: Returns the status message in the format:
AAaaBBCCccDDddEFGHIJKLMNOP<cr><lf>
where:
AA: measurement error code
aa: entry error code
BB: operating mode
CC: sensor A range
cc: sensor B range
DD: sensor A filter
dd: sensor B filter
E: measurement units
F: active entry channel
G: OSC status
H: REL mode status
I: trigger mode
J: group trigger mode
K: limits checking status
L: sensor A limits status
M: sensor B limits status
others not used
Syntax: ST<val>EN
val: 1 to 10
Remarks: Stores the present configuration to the selected register.
Example: To store the current instrument configuration in register 2:
ST2EN
Related
commands:
RC
To Next Page
Loading...
