HP437B Emulation Commands GPIB Operation
8-102 PN: 10585-00001 Rev. P ML2437A/38A OM/PM
8-12 HP437B Emulation Commands
This section provides an alphabetical listing of the commands (mnemonics) used to program
the Model ML243xA Power Meter when in HP437B Emulation mode. The emulation mode
can be set through the front panel SYSTEM > Rear Panel > GPIB > MODE menu or through
the GPIB command EMUL.
HP Emulation commands must not
have a space between the command header and the
parameter, or commas between the parameters.
The format for HP Emulation commands is:
<command header><paramet
er 1><parameter n>...
The end of the command text must be terminated with a line feed character (0Ah, decimal 10)
or a GPIB End of Transmission State (EOI), or both.
To Next Page
Loading...
