ML24xxA Native Commands GPIB Operation
8-68 PN: 10585-00001 Rev. P ML2437A/38A OM/PM
RSBAUD (RS232 Baud Rate)
RSMODE (RS232 Operating Mode)
SECURE (Secure system state)
Syntax: RSBAUD <val>
val: 12,24,48,96,192 or 384 hundred bits per second
Remarks: Sets the RS232 Baud rate for the rear panel serial port.
Query: RSBAUD?
Returned String: RSBAUD <val>
Syntax: RSMODE <s>
s: EXTCOM
SRCSWP
Remarks: EXTCOM = External communication. GPIB commands are sent and
received via an RS232 connection.
SRCSWP = Source sweep. Connected to a sweeper so updates to the
sweepers power of frequencies etc. are automatically updated on the
ML243xA also.
Query: RSMODE?
Returned String: RSMODE <s>
Syntax: SECURE <state>
state: ON or OFF
Remarks: Normally when the system is powered on the ML243xA returns to the
state it was in when it was powered off. This includes all the offset
tables, calibration adjust values, etc.
If Secure is set to ON, non-volatile memory is disabled and all stored
values are reset to the factory defaults when the system is powered on.
As long as this command is ON, the system will load the presets (see
Appendix B) every time it is turned ON.
Query: SECURE?
Returned String: SECURE <s>
To Next Page
Loading...
