GPIB Operation ML24xxA Native Commands
ML2437A/38A OM/PM PN: 10585-00001 Rev. P 8-77
TEXT (User text command)
TEXTS (User text display command)
TR0 (Trigger hold mode)
Syntax: TEXT <text string>
text string: Text string of up to 20 characters
Remarks: Defines the text string that will be displayed using the TEXTS
command.
Related
commands:
TEXTS
Query: TEXT?
Returned String: TEXT <text string>
Syntax: TEXTS <state>
state: ON or OFF
Remarks: This command turns on or off the display of text entered using the TEXT
command. Up to 20 characters of user text can be displayed on the top
line of the data screen for READOUT, PROFILE and PWRvsTIME
display modes.
Related
commands:
TEXT
Query: TEXTS?
Returned String: TEXTS <state>
Syntax: TR0
Remarks: Sets both channels to trigger hold mode. It does not trigger until it
receives a TR1 or TR2 or GET (group executive trigger), *TRG or TR3
command. If it receives a TR3 command it reverts back to the trigger
mode it was in before the TR0 command was sent. If the REM line is
low, this command has no effect.
Related
commands:
TR1, TR2, TR3, *TRG, Group Execute Trigger (GET), GT0, GT1, GT2
To Next Page
Loading...
