GPIB Operation HP438A Emulation Commands
ML2437A/38A OM/PM PN: 10585-00001 Rev. P 8-121
8-13 HP438A Emulation Commands
This section provides an alphabetical listing of the GPIB commands (mnemonics) used to
program the Model ML243xA Power Meter when in HP438A Emulation mode. The emulation
mode can be set through the front panel SYSTEM > more > more > Rear panel > GPIB >
MODE menu or through the GPIB command EMUL.
HP Emulation commands must not
have a space between the command header and the
parameter, or commas between the parameters.
The format for HP Emulation commands is:
<command header><parameter 1><parameter n>...
The end of the command text must be terminated with a line feed character (0Ah, decimal 10)
or a GPIB End of Transmission State (EOI), or both.
The ML243xA in HP438A emulation mode also supports the HP437B cal factor table edit and
read commands.
To Next Page
Loading...
