Preparing for Shipment Installation
2-6 PN: 10585-00001 Rev. P ML2437A/38A OM/PM
1. Wrap the ML243xA to protect the finish.
2. Position the ML243xA in the original shipping container.
3. Insert cushioning material between the ML243xA and the container. Pack the
cushioning material tightly in place while taking care not to put pressure on the RF
connector on the front panel.
4. Seal the container carefully; use shipping tape or an industrial stapler.
5. Return the container to the appropriate Anritsu service center. The address of your local
service center can be found at: https://www.anritsu.com/en-US/Contact-US/
Note
If the original shipping container is no longer available, use a strong corrugated
cardboard container that is at least 15 cm larger than the ML243x8A.
To Next Page
Loading...
