Anritsu ML2437A - Page 283

System Error Messages
ML2437A/38A OM/PM PN: 10585-00001 Rev. P B-11
Put sensor number limit Attempt to read/write sensor B setup on
ML2437A
Sensor x cal factor error Cal factor out of range - sensor x
PUT current mode limit Present configuration will not allow requested
change.
Internal error (P6) Entered numeric value out of range
Internal error (P10) Requested action NOT allowed
Internal error (P20) Cal factor edit - duplicate frequency entered
Internal error (P21) Cannot delete last cal factor data pair in
selected table, or cannot add cal factor data
pair in selected table
Internal error (P22) Cannot delete 50 MHz cal factor in selected
table
Internal error (P23) Non valid cal factor table
Table B-1. Error Messages
Error Message Meaning