Front Panel Operation System Menu
ML2437A/38A OM/PM PN: 10585-00001 Rev. P 5-29
Source Sweep mode
CLEAR [GPRST]
Available in Profile, Source Sweep and Power vs. Time modes when the DATA HOLD
representation selection is not set to NORMAL (or AVERAGE for Power vs. Time).
Pressing the CLEAR key restarts the min/max collection.
T1 Time at cursor 1
T2 Time at cursor 2
Data hold = MIN&MAX:
1 cursor 1 MIN reading
cursor 1 MAX reading
2 cursor 2 MIN reading
cursor 2 MAX reading
△ t Time difference between cursor 1 and cursor 2
Data hold = NORMAL or AVERAGE:
1 cursor 1 reading
2 cursor 2 reading
△ P Power difference between cursor 1 and cursor 2
X1 X axis at cursor 1
X2 X axis at cursor 2
Data hold = MIN (or MAX) :
1 cursor 1 minimum reading, or maximum if MAX mode
2 cursor 2 minimum reading, or maximum if MAX mode
△ P Power diff between cursor 1 and cursor 2 minimums
(or maximums if MAX mode)
X1 X axis at cursor 1
X2 X axis at cursor 2
Data hold = MIN&MAX:
1 cursor 1 MIN reading
cursor 1 MAX reading
2 cursor 2 MIN reading
cursor 2 MAX reading
To Next Page
Loading...
