Branson 2000X - Page 188

Chapter 6: Operation
Using the System Configuration Menu
6-96 011-003-991 EN
Selecting Units for the Power Supply
You can choose to use USCS or metric units for measurements in the Power Supply.
Take this action… To get this result…
Press the Select key that corresponds to
Units.
Press the Select key repeatedly to toggle
between USCS and Metric. Press the
Enter key on the numeric keypad when you
have set Units to the value you want.
SYS CONFIG Pg1of19
Units =USCS
Password> =Off
Start Screen =Run
Select
Select
Select
SYS CONFIG Pg1of19
Units =Metric
Password> =Off
Start Screen =Run
Select
Select
Select
Select