Branson 2000X - Page 202

Chapter 6: Operation
Using the System Configuration Menu
6-110 011-003-991 EN
Setting the Cylinder Diameter
Take this action… To get this result…
From the System Configuration menu,
press the Select key that corresponds to
Act Settings.
You will see the ACT SETTING submenu.
Press the Select key that corresponds to
Cyl Dia.
SYS CONFIG Pg12of19
Beepers>
Amp Control =Int
Act Settings>
Select
Select
Select
ACT SETTING Pg1of1
Cyl Dia (in)> 1.5
Cyl Stroke (in)> 4.0
Custom>
Select
Select
Select