Branson 2000X - Page 216

Chapter 6: Operation
Using the System Configuration Menu
6-124 011-003-991 EN
Setting the Frequency Offset Control
NOTE
i
Do not use this feature unless advised to do so by Branson.
Take this action… To get this result…
Press the Select key that corresponds to
Freq Offset.
Press the Select key repeatedly to toggle
between Int and Ext. Press the Enter key
on the numeric keypad when you have set
Freq Offset to the value you want.
You will return to the Main Menu.
SYS CONFIG Pg19of19
Bargraph Scales>
Digital Filter =On
Freq Offset =Int
Select
Select
Select
SYS CONFIG Pg19of19
Bargraph Scales>
Digital Filter = On
Freq Offset = Ext
Select
Select
Select