7-11
After configuring the parameters, use one of the function menus noted below to perform the
corresponding calculation.
• { BAL } … {balance of principal after installment PM2}
• { INT } … {interest portion of installment PM1}
• { PRN } … {principal portion of installment PM1}
• { Σ INT } … {total interest paid from installment PM1 to installment PM2}
• { Σ PRN } … {total principal paid from installment PM1 to installment PM2}
• { COMPND } … {compound interest screen}
• An error occurs if parameters are not configured correctly.
Use the following function menus to maneuver between calculation result screens.
• { REPEAT } … {parameter input screen}
• { COMPND } … {compound interest screen}
• { GRAPH } … {draws graph}
After drawing a graph, you can press !1(TRACE) to turn on trace and read calculation
results along the graph.
The first press of !1(TRACE) displays
INT and PRN when n = 1. Each press of e
shows INT and PRN when n = 2, n = 3, and so on.
Press J to return to the parameter input screen.
To Next Page
Loading...
