14-20
3. Press x or perform the following operation: 2(Edit) – 4:Select Figure.
• This selects the entire object.
u To deselect a particular object
1. If any tool icon is in the upper right corner of the screen, press J or o to deselect the
tool.
2. Move the pointer close to the object you want to deselect.
• This will cause the k marks to become highlighted. At this time the object will begin to
flash. Note that the object will not flash if it is a point and a k mark is displayed on the
point.
→
3. Press w.
• This will deselect the object, which causes the k mark(s) to disappear.
u To select all objects on the screen
Perform the following operation: 2(Edit) – 2:Select All.
u To deselect all objects on the screen
Press o or perform the following operation: 2(Edit) – 3:Deselect All.
To Next Page
Loading...
