To Next Page

To Previous Page

14-24

u To construct the point of intersection of two lines

1. Draw to intersecting line segments and select them.

2. Perform the following operation: 4(Construct) – 4:Intersection.

• This plots the point where the two line segments intersect.

→

Note

You can construct the point of intersection of two lines while two of any of the following objects

(two of the same object or two different objects) are selected on the screen: line segment, line,

rays, vector, side of a polygon, circle, or arc.

u To construct an angle bisector

1. Draw a triangle and select two of its sides.

2. Perform the following operation: 4(Construct) – 5:Angle Bisector.

• This draws the bisector of the angle formed by the two sides of the triangle that you

selected.

→

Note

• You can perform an angle bisector construct operation while two of any of the following

objects (two of the same object or two different objects) are selected on the screen: line

segment, line, ray, vector, or one side of a polygon.

• If the two objects you select are intersecting, the angle bisector construct operation will

construct two angle bisectors.

Casio FX-CG20 AU User Manual

Questions and Answers: