To Next Page

To Previous Page

ε-23

Using the MULTIMETER Mode

5. Using the MULTIMETER Mode

You can use the Channel Setup screen (page ε-9) to configure a channel so that Data

Logger

MULTIMETER mode sampling is triggered by a calculator operation.

• To use the MULTIMETER mode

1. Connect the calculator and Data Logger, and connect the sensors you want to the

applicable Data Logger channels.

2. From the Advanced Setup menu (page

ε-8), use the Channel Setup screen (page ε-9) to

configure sensor setups for each channel you will be using.

3. After configuring the sensor setups, press w to return to the Advanced Setup menu

(page

ε-8), and then press 2(MULTI).

• This starts sampling in the

Data Logger

MULTIMETER mode and displays a list of sample

values for each channel.

• Displayed sample data is refreshed at 0.5-second

intervals.

• Do not connect sensors to any other channels except

for those you specified in step 2.

• Data sampled in the MULTIMETER mode is not saved in memory.

4. To end MULTIMETER mode sampling, press the w key.

Casio FX-CG20 AU User Manual

Questions and Answers: