description (T1/E1)
To configure a description for a T1 or E1 controller, use the description command in T1 or E1 configuration
mode. To delete a T1 or E1 controller description, use the no form of this command.
description text
no description [ text ]
Syntax Description
A text string comprised of alphanumeric characters.
text
Command Default
No description is configured.
Command Modes
T1 configuration
E1 configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Support for E1 configuration was added.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writesonet-sdh
read, writeinterface
Examples
The following example shows how to configure a description for a T1 controller:
RP/0/RSP0/CPU0:router(config)# controller t1 0/6/2/0
RP/0/RSP0/CPU0:router(config-t1)# description This is a sample description for T1 controller
0/6/2/0
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
986
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
description (T1/E1)
To Next Page
Loading...
Need help?
General
