pm otn threshold
To configure performance monitoring thresholds on the optical transport network (OTN) layer, use the pm
otn threshold command in DWDM configuration mode. To disable TCA reporting, use the no form of this
command.
pm {15-min| 24-hour} otn threshold otn-paramter enable
no pm {15-min| 24-hour} otn threshold otn-paramter enable
Syntax Description
Configures performance monitoring thresholds for 15-minute intervals.15-min
Configures performance monitoring thresholds for 24-hour intervals.24-hour
Specific parameter for which to configure the threshold. OTN parameters can be as follows:
• bbe-pm-fe—Far-end path monitoring background block errors (BBE-PM). Indicates
the number of background block errors recorded in the optical transport network (OTN)
path during the performance monitoring time interval.
• bbe-pm-ne—Near-end path monitoring background block errors (BBE-PM).
• bbe-sm-fe—Far-end section monitoring background block errors (BBE-SM). Indicates
the number of background block errors recorded in the OTN section during the
performance monitoring time interval.
• bbe-sm-ne—Near-end section monitoring background block errors (BBE-SM).
• bber-pm-fe—Far-end path monitoring background block errors ratio (BBER-PM).
Indicates the background block errors ratio recorded in the OTN path during the
performance monitoring time interval.
• bber-pm-ne—Near-end path monitoring background block errors ratio (BBER-PM).
• bber-sm-fe—Far-end section monitoring background block errors ratio (BBER-SM).
Indicates the background block errors ratio recorded in the OTN section during the
performance monitoring time interval.
• bber-sm-ne—Near-end section monitoring background block errors ratio (BBER-SM)
• es-pm-fe—Far-end path monitoring errored seconds (ES-PM). Indicates the errored
seconds recorded in the OTN path during the performance monitoring time interval.
• es-pm-ne—Near-end path monitoring errored seconds (ES-PM).
• es-sm-fe—Far-end section monitoring errored seconds (ES-SM). Indicates the errored
seconds recorded in the OTN section during the performance monitoring time interval.
• es-sm-ne—Near-end section monitoring errored seconds (ES-SM).
otn-parameter
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
43
Dense Wavelength Division Multiplexing Commands on the Cisco ASR 9000 Series Router
pm otn threshold
To Next Page
Loading...
Need help?
General
