log crosscheck errors
To enable logging of crosscheck error events, use the log crosscheck errors command in CFM domain service
configuration mode. To disable logging of crosscheck error events, use the no form of this command.
log crosscheck errors
no log crosscheck errors
Syntax Description
This command has no keywords or arguments.
Command Default
Logging is disabled.
Command Modes
CFM domain service configuration (config-cfm-dmn-svc)
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
This command enables logging of crosscheck errors, such as:
•
MEPs missing
•
Additional peer MEPs detected
Crosscheck errors are only detected and logged when crosscheck is configured using the mep crosscheck
and mep-id commands.
Note
Task ID
OperationsTask ID
read, writeethernet-services
Examples
The following example shows how to enable logging of crosscheck errors:
RP/0/RSP0/CPU0:router# configure
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
268
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
log crosscheck errors
To Next Page
Loading...
Need help?
General
