encapsulation ppp
To enable encapsulation for communication with routers or bridges using the Point-to-Point Protocol (PPP),
use the encapsulation ppp command in interface configuration mode. To disable PPP encapsulation, use the
no form of this command.
encapsulation ppp
no encapsulation ppp
Syntax Description
This command has no keywords or arguments.
Command Default
PPP encapsulation is disabled.
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the encapsulation ppp command to enable PPP encapsulation on an interface.
Task ID
OperationsTask ID
read, writeppp
read, writeinterface
Examples
The following example shows how to set up PPP encapsulation on interface POS 0/1/0/1:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface POS 0/1/0/1
RP/0/RSP0/CPU0:router(config-if)# encapsulation ppp
The following example shows how to set up PPP encapsulation on a serial interface:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router# interface serial 0/0/1/2/4:3
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
714
PPP Commands onthe Cisco ASR 9000 Series Router
encapsulation ppp
To Next Page
Loading...
Need help?
General
