show efd interface
To display all interfaces that are shut down because of Ethernet Fault Detection (EFD), or to display whether
a specific interface is shut down because of EFD, use the show efd interface command in EXEC mode.
show efd interface [type interface-path-id]
Syntax Description
(Optional) Interface type. For more information, use the question mark (?) online
help function.
type
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces currently
configured on the router.
Note
For more information about the syntax for the router, use the question mark (?) online
help function.
interface-path-id
Command Default
If no parameters are specified, all interfaces that are shut down because of EFD are displayed.
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.Release 3.9.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
If this command is issued when no EFD errors are detected, the system displays the following message:
< date time >
No matching interfaces with EFD-shutdown triggered
Task ID
OperationsTask ID
read, writeethernet-services
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
318
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
show efd interface
To Next Page
Loading...
Need help?
General
