show controllers backplane ethernet location multicast groups
To display information about backplane interfaces that are in multicast groups in a particular location, use the
show controllers backplane ethernet location multicast groups command in EXEC mode.
show controllers backplane ethernet location multicast groups
Syntax Description
This command has no keywords or arguments.
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Examples
The following example shows the output from the show controllers backplane ethernet location multicast
groups command, which displays detailed information about the backplane interfaces.
RP/0/RSP0/CPU0:router# show controllers backplane ethernet location multicast groups
Intf Multicast Client registered for this address
Name address Id Name
------------------------------------------------------------------------------
FastEthernet0_2_CPU0 0100.0000.0064 2 GSP
0100.0000.0065 2 GSP
0100.0000.0066 2 GSP
0100.0000.0068 2 GSP
0100.0000.006a 2 GSP
0100.0000.006c 2 GSP
0100.0000.006e 2 GSP
0100.0000.0071 2 GSP
0100.0000.2774 2 GSP
0100.0000.2775 2 GSP
0100.0000.2776 2 GSP
0100.0000.2778 2 GSP
0100.0000.277a 2 GSP
0100.0000.2782 2 GSP
0100.0000.278a 2 GSP
0100.0000.2796 2 GSP
0100.0000.2798 2 GSP
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
550
Internal Ethernet Control Network Commands on the Cisco ASR 9000 Series Router
show controllers backplane ethernet location multicast groups
To Next Page
Loading...
Need help?
General
