mlacp switchover maximize
To set the maximum number of links or bandwidth in the bundle, use the mlacp switchover maximizecommand
in the bundle interface configuration mode.
mlacp switchover maximize { links | bandwidth }[threshold value]
Syntax Description
Compares the operational links, with respect to the total number of links.links
Compares the available bandwidth, with respect to the total bandwidth.bandwidth
Sets the threshold value to switch to the peer, if its has more links/ bandwidth available.threshold
•
When used with the links keyword, sets the minimum number of links, below
which the device switches to the peer if more links are available. Range is 1-64.
•
When used with the bandwidth keyword, sets the minimum bandwidth (in kbps),
below which the device switches to the peer if more bandwidth is available.
Range is 1-4294967295.
value
Command Default
No default behavior or value.
Command Modes
Bundle interface configuration.
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper task
IDs. If you suspect user group assignment is preventing you from using a command, contact your AAA
administrator.
This command allows switchovers to take place such that the active device is the one with most bandwidth
or maximum links in the bundle.
Task ID
OperationTask ID
read,writebundle
read,writeinterface
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
506
Global Interface Commandsonthe Cisco ASR 9000 Series Router
mlacp switchover maximize
To Next Page
Loading...
Need help?
General
