Task ID
OperationsTask ID
read, writefr
Examples
The following example shows how to configure the MFR acknowledge timeout value as 2 seconds. for the
serial interface 0/3/1/0:
RP/0/RSP0/CPU0:router(config)# interface serial 0/3/1/0
RP/0/RSP0/CPU0:router(config-if)# frame-relay multilink ack 2
Related Commands
DescriptionCommand
Enables Frame Relay encapsulation.encapsulation frame-relay, on page 429
Assigns a BID name to a multilink Frame Relay
bundle.
frame-relay multilink bid, on page 452
Displays frame relay information for the LMI.show frame-relay lmi-info, on page 465
Disables an interface.shutdown (interface)
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
449
Frame Relay Commands on the Cisco ASR 9000 Series Router
frame-relay multilink ack
To Next Page
Loading...
Need help?
General
