mlacp port-priority
To set the priority for all member links, use the mlacp port-priority command in bundle interface configuration
mode. To return to the default value, use the no form of this command.
mlacp port-priority priority
no mlacp port-priority priority
Syntax Description
Specifies the priority for member ports. The priority value ranges between 1-65535.
A lower value indicates higher priority.
priority
Command Default
No default behavior or values
Command Modes
Bundle interface configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeBundle
Examples
This example shows how to set the priority for all member links:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface Bundle-Ether 30
RP/0/RSP0/CPU0:router(config-if)# mlacp port-priority 20
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
612
Link Bundling Commands on the Cisco ASR 9000 Series Router
mlacp port-priority
To Next Page
Loading...
Need help?
General
