mode (SONET)
To set the mode of an STS path, AU path, T3 controller, or TUG3 controller, use the mode command in the
applicable controller configuration mode. To disable the mode, use the no form of this command.
STS Controller Configuration Mode
mode {t3| vt15-t1| pos}
no mode {t3| vt15-t1| pos}
AU Controller Configuration Mode
mode {e3| t3| tug 3}
no mode {e3| t3| tug 3}
T3 Controller Configuration Mode
mode {e1| serial| t1}
no mode {e1| serial| t1}
TUG3 Controller Configuration Mode
mode {c12| c12-e1| e3| serial| t3}
no mode {c12| c12-e1| e3| serial| t3}
Syntax Description
Specifies the mode of the port to be channelized as an AU3 or a TUG3 path carrying
T3.
t3
Specifies the mode of the port to be channelized VT15-T1.vt15-t1
Specifies the mode of the port to be channelized POS.pos
Specifies the mode of the port to be channelized TUG3.tug3
Specifies the mode of the port to be channelized E1.e1
Specifies the mode of the port to be clear channel serial.serial
Specifies the mode of the port to be channelized T1.t1
Specifies the mode of the port to be channelized as a TUG3 path carrying TU-12.c12
Specifies the mode of the port to be channelized be TUG3 path carrying c12 to E1.c12-e1
Specifies the mode of the port to be channelized as an AU3 or a TUG3 path carrying
E3.
e3
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
874
SONET Controller Commands on the Cisco ASR 9000 Series Router
mode (SONET)
To Next Page
Loading...
Need help?
General
