frame-relay lmi-t391dte
To set the Local Management Interface (LMI) polling interval, use the frame-relay lmi-t391dte command
in interface configuration mode. To restore the default interval value, use the no form of this command.
frame-relay lmi-t391dte seconds
no frame-relay lmi-t391dte seconds
Syntax Description
Polling interval between each status inquiry from the DTE end, in seconds. Range
is from 5 to 30. The default is 10.
seconds
Command Default
The LMI polling interval is 10 seconds.
Command Modes
Interface configuration (config-if)
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
This frame-relay lmi-t391dte command is available on Packet-over-SONET/SDH (POS), serial, and multilink
interfaces.
The seconds value defined in this command must be less than the polling verification timer defined in the
frame-relay lmi-t392 dce command.
The frame-relay lmi-t391dte command is relevant only when the interface type is data terminal equipment
(DCE).
Task ID
OperationsTask ID
read, writefr
Examples
The following example shows how to set the LMI polling timer interval to 15 seconds:
RP/0/RSP0/CPU0:router(config)# interface pos 0/1/0/1
RP/0/RSP0/CPU0:router(config-if)# frame-relay intf-type dte
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
442
Frame Relay Commands on the Cisco ASR 9000 Series Router
frame-relay lmi-t391dte
To Next Page
Loading...
Need help?
General
