g709 odu report disable
To disable the logging of selected Optical Channel Data Unit (ODU) alarms to the console for a DWDM
controller, use the g709 odu report disable command in DWDM configuration mode. To return to the default
state, use the no form of this command.
g709 odu report {ais| bdi| lck| oci| ptim| tim} disable
no g709 odu report {ais| bdi| lck| oci| ptim| tim} disable
Syntax Description
Alarm indication signal reporting status.ais
Backward defect indication reporting status.bdi
Upstream connection locked reporting status.lck
Open connection indication error reporting status.oci
Payload type identifier mismatch reporting status.ptim
Set Trace Identifier Mismatch reporting status.tim
Command Default
Reporting is enabled for all keywords.
Command Modes
DWDM configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writedwdm
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
13
Dense Wavelength Division Multiplexing Commands on the Cisco ASR 9000 Series Router
g709 odu report disable
To Next Page
Loading...
Need help?
General
