snmp-server traps ethernet cfm
To enable SNMP traps for Ethernet Connectivity Fault Management (CFM), use the snmp-server traps
ethernet cfm command in global configuration mode.
snmp-server traps ethernet cfm
Syntax Description
This command has no keywords or arguments.
Command Default
Ethernet OAM event traps are not enabled.
Command Modes
Global configuration (config)
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
If a Local MEP is receiving Wrong Level CCMs, then a transient timeout might occur when correct Level
CCMs are received again.
Task ID
OperationsTask ID
read, writesnmp
Examples
The following example shows how to enable SNMP server traps on an Ethernet OAM interface.
RP/0/RSP0/CPU0:router #configure
RP/0/RSP0/CPU0:router(config)# snmp-server traps ethernet cfm
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
400
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
snmp-server traps ethernet cfm
To Next Page
Loading...
Need help?
General
