ssrp profile
To configure a Session State Redundancy Protocol (SSRP) profile and enter the SSRP configuration mode,
use the ssrp profile command in global configuration mode. To remove the profile, use the no form of this
command.
ssrp profile profile-name
no ssrp profile profile-name
Syntax Description
Name of this SSRP profile.
profile-name
Command Default
No default behavior or values
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
A Session State Redundancy Protocol (SSRP) profile allows the same SSRP configuration to be shared across
multiple groups. The same profile can be attached to multiple groups across the router. The group must be
configured before the interface that uses the group can be configured. The group number is used in the TCP
port number so, the group number must be unique across the router.
Task ID
OperationsTask ID
read, writeppp
Examples
This example shows how to configure an SSRP profile:
RP/0/RSP0/CPU0:router# config
RP/0/RSP0/CPU0:router(config)# ssrp profile Profile_1
RP/0/RSP0/CPU0:router(config-ssrp)#
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
774
PPP Commands onthe Cisco ASR 9000 Series Router
ssrp profile
To Next Page
Loading...
Need help?
General
