show frame-relay lmi-info
To display Frame Relay information for the Local Management Interface (LMI), use the show frame-relay
lmi -info command in EXEC mode.
show frame-relay lmi-info [interface type interface-path-id| location node-id] [detail]
Syntax Description
(Optional) Displays information on the the interface specified by the type
interface-path-id argument.
interface
Interface type. For more information, use the question mark (?) online help
function.
type
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces currently
configured on the router.
Note
For more information about the syntax for the router, use the question mark (?)
online help function.
interface-path-id
(Optional) Displays information about all interfaces on the specified node. The
node-id argument is entered in the rack/slot/module notation.
location node-id
(Optional) Displays managed dcli list.detail
Command Default
Displays LMI information for all Frame Relay interfaces enabled for LMI.
Command Modes
EXEC (#)
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The show frame-relay lmi-info command is available on Packet-over-SONET/SDH (POS), serial, and
multilink interfaces.
This command is used to check the status enquiry and status message between DCE and DTE.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
465
Frame Relay Commands on the Cisco ASR 9000 Series Router
show frame-relay lmi-info
To Next Page
Loading...
Need help?
General
