packet-gap non-standard
To change the packet interval for traffic on an interface for improved interoperability with Cisco Catalyst
6000 series switches, use the packet-gap non-standard command in interface configuration mode. To use
the standard packet interval as defined by the IEEE 802.ae specification, use the no form of this command.
packet-gap non-standard
no packet-gap non-standard
Syntax Description
This command has no keywords or arguments.
Command Default
The interface uses the standard packet interval as defined by the IEEE 802.ae specification.
Command Modes
Interface configuration
Command History
ModificationRelease
This command was first introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
An interface that is connected to a Cisco Catalyst 6000 series switch may experience packet loss problems
that can be resolved by changing the packet interval of traffic from standard (as defined by the IEEE 802.ae
specification) to nonstandard using the packet-gap non-standard command.
The packet-gap non-standard command is available on 10-Gigabit Ethernet interfaces only.Note
Task ID
OperationsTask ID
read, writeinterface
Examples
This example shows how to change the packet interval for traffic on an interface from standard to nonstandard:
RP/0/RSP0/CPU0:router(config)# interface TenGigE 0/3/0/0
RP/0/RSP0/CPU0:router(config-if)# packet-gap non-standard
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
104
Ethernet Interface Commands on the Cisco ASR 9000 Series Router
packet-gap non-standard
To Next Page
Loading...
Need help?
General
