• Received packet rate – displayed in packets per second when at least two responses are received. This
approximate rate of response is the time between the first response received and the last response received,
divided by the total number of responses received.
Task ID
OperationsTask ID
executebasic-services
executeethernet-services
Examples
The following example shows how to send an Ethernet CFM loopback message:
RP/0/RSP0/CPU0:router# ping ethernet cfm domain D1 service S1 mep-id 16 source
interface GigabitEthernet 0/0/0/0
Type escape sequence to abort.
Sending 5 CFM Loopbacks, timeout is 2 seconds -
Domain foo (level 2), Service foo
Source: MEP ID 1, interface GigabitEthernet0/0/0/0
Target: 0001.0002.0003 (MEP ID 16):
Running (5s) ...
Success rate is 60.0 percent (3/5), round-trip min/avg/max = 1251/1349/1402 ms
Out-of-sequence: 0.0 percent (0/3)
Bad data: 0.0 percent (0/3)
Received packet rate: 1.4 pps
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
293
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
ping ethernet cfm
To Next Page
Loading...
Need help?
General
