symbol-period threshold
To configure the thresholds that trigger an Ethernet OAM symbol-period error event, use the symbol-period
threshold command in Ethernet OAM link monitor configuration mode. To return the threshold to the default
value, use the no form of this command.
symbol-period threshold low threshold [high t hreshold]
no symbol-period threshold low threshold [high t hreshold]
Syntax Description
Low threshold value, in symbols, that triggers a symbol-period error event. The
range is 0 to 60000000.
low threshold
(Optional) High threshold value, in symbols, that triggers a symbol-period error
event. The range is 0 to 60000000. The high threshold value can be configured
only in conjunction with the low threshold value.
high threshold
Command Default
The default low threshold is 1.
Command Modes
Ethernet OAM link monitor configuration (config-eoam-lm)
Interface Ethernet OAM link monitor configuration (config-if-eoam-lm)
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
When the low threshold is passed, a symbol-period error event notification is generated and transmitted to
the OAM peer. Additionally, any registered higher level OAM protocols, such as Connectivity Fault
Management (CFM), are also notified. When the high threshold is passed, the configured high threshold action
is performed in addition to the low threshold actions. The high threshold is optional and is configurable only
in conjunction with the low threshold.
Task ID
OperationsTask ID
read, writeethernet-services
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
406
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
symbol-period threshold
To Next Page
Loading...
Need help?
General
