mlacp system priority
To configure the LACP system priority to be used in the ICCP group, use the mlacp system priority command
in the redundancy ICCP group configuration mode. To return to the default value, use the no form of this
command.
mlacp system priority priority
no mlacp system priority priority
Syntax Description
Specifies the priority for the system.
Lower value indicates higher
priority.
Note
priority
Command Default
No default behavior or values
Command Modes
Redundancy ICCP group configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writebundle
Examples
This example shows how to configure the LACP system priority to be used in the ICCP Group:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# redundancy iccp group 10
RP/0/RSP0/CPU0:router(config-redundancy-iccp-group)# mlacp system priority 10
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
615
Link Bundling Commands on the Cisco ASR 9000 Series Router
mlacp system priority
To Next Page
Loading...
Need help?
General
