lacp packet-capture
To capture LACP packets so that their information can be displayed by the show lacp packet-capture
command, use the lacp packet-capture command in EXEC mode.
{lacp packet-capture gigabitethernet interface-path-id| tengige interface-path-id number-of-packets}
To stop capturing LACP packets or to clear captured LACP packets, use the lacp packet-capture stop or
lacp packet-capture clear command in EXEC mode.
{lacp packet-capture [bundle-ether bundle-id] [gigabitethernet interface-path-id] [tengige interface-path-id]
clear| stop}
Syntax Description
Ethernet bundle interface specified by bundle-id.
bundle-ether
Gigabit Ethernet interface specified by interface-path-id.
GigabitEthernet
Ten Gigabit Ethernet interface specified by interface-path-id.
TenGigE
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces
currently configured on the router.
Note
For more information about the syntax for the router, use the question mark
(?) online help function.
interface-path-id
Number specifying the bundle interface. The range is 1 to 65535.
bundle-id
Number of packets to capture.
number-of-packets
Clears all currently captured packets.clear
Stops capturing packets.stop
Command Default
The default (no parameters) executes globally for all interfaces on the line card.
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
599
Link Bundling Commands on the Cisco ASR 9000 Series Router
lacp packet-capture
To Next Page
Loading...
Need help?
General
