ppp pap refuse
To refuse Password Authentication Protocol (PAP) authentication from peers requesting it, use the ppp pap
refuse command in interface configuration mode. To allow PAP authentication, use the no form of this
command.
ppp pap refuse
no ppp pap refuse
Syntax Description
This command has no keywords or arguments.
Command Default
PAP authentication is disabled.
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The ppp pap refuse command specifies that PAP authentication is disabled for all calls, meaning that all
attempts by the peer to force the user to authenticate using PAP are refused.
If outbound Challenge Handshake Authentication Protocol (CHAP) has been configured (using the ppp
authentication command), CHAP is suggested as the authentication method in the refusal packet.
Task ID
OperationsTask ID
read, writeppp
read, writeaaa
Examples
The following example shows how to specify POS 0/3/0/1 using PPP encapsulation on the interface. This
example shows PAP authentication being specified as disabled if a peer calls in requesting PAP authentication.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface POS 0/3/0/1
RP/0/RSP0/CPU0:router(config-if)# encapsulation ppp
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
748
PPP Commands onthe Cisco ASR 9000 Series Router
ppp pap refuse
To Next Page
Loading...
Need help?
General
