Specifies the range of the samples
to be collected within each bin in
milliseconds, from 1 to 10000.
Based on the specified width, bins
are established in the following
way:
•
Delay measurements
(round-trip or one-way)—The
lower bound of the bins is
zero and the first bin’s upper
limit is 0 plus the specified
width, and the last bin is
unbounded.
•
Jitter measurements
(round-trip or one-way)—The
bins are evenly distributed
around zero, with both the
lowest and highest numbered
bins being unbounded.
See the Usage Guidelines for more
information.
width milliseconds
(Optional) Specifies the number of
buckets to store in memory from 1
to 100. The default is 100.
buckets archive number
(Optional) Specifies the number of
buckets to be used for probes from
1 to 100. The default is 1.
buckets size number
Specifies that probes span multiple
buckets.
per-probe
Specifies that buckets span multiple
probes.
probes
(Optional) Specifies that the probe
begins as soon as you enter the
command. This is the default.
schedule now
(Optional) Specifies a specific time
at which to start the probe in
24-hour notation.
schedule at hh:mm
(Optional) Number of seconds into
the next minute at which to start the
probe.
ss
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
228
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
ethernet sla on-demand operation type cfm-delay-measurement probe
To Next Page
Loading...
Need help?
General
