show iphc idb
To display status information for an IP header compression (IPHC) interface description block (IDB), use the
show iphc idb command in EXEC mode.
show iphc idb {detail| interface type interface-path-id [detail]| location node-id [detail]}
Syntax Description
Includes statistics information and internal data.detail
Specifies the interface for which IPHC information is to be displayed.interface
Interface type. For more information, use the question mark (?) online help function.
type
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces currently
configured on the router.
Note
For more information about the syntax for the router, use the question mark (?)
online help function.
interface-path-id
Specifies the node location for which IPHC information is to be displayed.location
Specifies the fully qualified path of a node.
For more information about the syntax for the router, use the question mark (?)
online help function.
node-id
Command Default
The default (no parameters) displays information for all interfaces configured for IPHC.
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
readip-services
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
810
Serial Interface Commands on the Cisco ASR 9000 Series Router
show iphc idb
To Next Page
Loading...
Need help?
General
