tug3
To specify the tributary unit group (TUG) number and enter the TUG3 controller configuration mode, use
the tug3 command in SONET controller configuration mode.
tug3 number
Syntax Description
The tributary unit group (TUG) number. The ranges are:
• AU4—The only value is 1.
• AU3—The range is 1 to 3.
number
Command Default
The default is 1.
Command Modes
SONET controller configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The tug3 command enables you to begin configuring the interface in the TUG3 controller configuration mode,
where you can configure virtual containers (VCs) and DS3s:
STM1 -> AU4 -> TUG3 -> VC-3 -> DS3
Task ID
OperationsTask ID
read, writesonet-sdh
Examples
The following example shows how to specify tug3 1.
RP/0/RSP0/CPU0:router(config)# controller sonet 0/1/0/0
RP/0/RSP0/CPU0:router(config-sonet)# au 1
RP/0/RSP0/CPU0:router(config-auPath)# tug3 1
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
927
SONET Controller Commands on the Cisco ASR 9000 Series Router
tug3
To Next Page
Loading...
Need help?
General
