Examples
The following example shows how to create a MEP using an ID of 1 on the CFM domain named DM1 and
service named Sv1:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface gigabitethernet 0/1/0/1
RP/0/RSP0/CPU0:router(config-if)# ethernet cfm
RP/0/RSP0/CPU0:router(config-if-cfm)# mep domain Dm1 service Sv1 mep-id 1
Related Commands
DescriptionCommand
Enters interface CFM configuration mode.ethernet cfm (interface), on page 209
Displays information about errors that are preventing configured
CFM operations from becoming active, as well as any warnings
that have occurred.
show ethernet cfm configuration-errors, on
page 322
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
280
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
mep domain
To Next Page
Loading...
Need help?
General
