EasyManuals Logo

Cisco A9K-SIP-700 Command Reference Guide

Cisco A9K-SIP-700
1138 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #545 background imageLoading...
Page #545 background image
DescriptionField
Average number of bits and
packets received per second in the
last 5 minutes. If the interface is
not in promiscuous mode, it senses
network traffic that it sends and
receives (rather than all network
traffic).
The 5-minute period
referenced in the
command output is a load
interval that is
configurable under the
interface. The default
value is 5 minutes.
Note
The 5-minute input should
be used only as an
approximation of traffic
per second during a given
5-minute period. This rate
is exponentially weighted
average with a time
constant of 5 minutes. A
period of four time
constants must pass before
the average will be within
two percent of the
instantaneous rate of a
uniform stream of traffic
over that period.
Note
5 minute input rate
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
525
Global Interface Commandsonthe Cisco ASR 9000 Series Router
show interfaces

Table of Contents

Other manuals for Cisco A9K-SIP-700

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco A9K-SIP-700 and is the answer not in the manual?

Cisco A9K-SIP-700 Specifications

General IconGeneral
BrandCisco
ModelA9K-SIP-700
CategoryNetwork Router
LanguageEnglish

Related product manuals