duplex (Management Ethernet)
To configure duplex mode operation on a Management Ethernet interface, use the duplex command in interface
configuration mode. To return the interface to autonegotiated duplex mode, use the no form of the duplex
command.
duplex {full| half}
no duplex
Syntax Description
Configures the Management Ethernet interface to operate in full duplex mode.full
Configures the Management Ethernet interface to operate in half duplex mode.half
Command Default
Autonegotiates duplex operation
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeinterface
Examples
The following example shows how to configure the Management Ethernet interface to operate in full duplex
mode:
RP/0/RSP0/CPU0:router(config)# interface MgmtEth 0/RSP0/CPU0/0
RP/0/RSP0/CPU0:router(config-if)# duplex full
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
666
Management Ethernet Interface Commands on the Cisco ASR 9000 Series Router
duplex (Management Ethernet)
To Next Page
Loading...
Need help?
General
