Specifies the source interface type
of the locally defined CFM MEP.
For more information, use the
question mark (?) online help
function.
source interface type
Physical interface or virtual
interface.
Use the show interfaces
command to see a list of
all interfaces currently
configured on the router.
Note
For more information about the
syntax for the router, use the
question mark (?) online help
function.
interface-path-id
Specifies the MAC address (in
dotted hexadecimal format) of the
target MEP that is known to the
local MEP for the probe.
target mac-address H.H.H.H
Specifies the ID (from 1 to 8191)
of the target MEP that is known to
the local MEP for the probe.
target mep-id id-number
(Optional) Specifies the type of
statistics to collect:
• one-way-delay-ds—One-way
delay statistics from
destination to source.
• one-way-delay-sd—One-way
delay statistics from source to
destination.
• one-way-jitter-ds—One-way
jitter statistics from
destination to source.
• one-way-jitter-sd—One-way
jitter statistics from source to
destination.
• round-trip-delay—Round-trip
delay statistics.
• round-trip-jitter—Round-trip
jitter statistics.
All statistics are collected by
default.
statistics measure
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
234
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
ethernet sla on-demand operation type cfm-loopback probe
To Next Page
Loading...
Need help?
General
