show ethernet cfm local meps
To display information about local maintenance end points (MEPs), use the show ethernet cfm local meps
command in EXEC mode.
show ethernet cfm local meps [domain domain-name [service service-name [mep-id id]]| interface type
interface-path-id [domain domain-name]] [errors [detail| verbose]| detail| verbose]
Syntax Description
(Optional) Displays information about the specified CFM domain, where
domain-name is a string of a maximum of 80 characters that identifies the domain
in which the maintenance points reside.
domain domain-name
(Optional) Displays information about the specified service, where service-name
is a string of a maximum of 80 characters that identifies the maintenance
association to which the maintenance points belong.
service service-name
(Optional) Displays information about the specified interface type. For more
information, use the question mark (?) online help function.
interface type
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces currently
configured on the router.
Note
For more information about the syntax for the router, use the question mark (?)
online help function.
interface-path-id
(Optional) Displays information about the specified MEP, where id is a number
of a local maintenance end point (MEP). The range is 1 to 8191.
mep-id id
(Optional) Displays information about peer MEPs with errors.errors
(Optional) Displays detailed information.detail
(Optional) Displays detailed information, plus counters for each type of CFM
packet.
verbose
Command Default
Brief information is displayed for all local MEPs.
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 3.7.2
New output fields were added for AIS.Release 3.9.1
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
333
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
show ethernet cfm local meps
To Next Page
Loading...
Need help?
General
