clear ethernet cfm peer meps
To clear all peer MEPs or peer MEPs for a specified local MEP, use the clear ethernet cfm peer meps
command in EXEC mode.
clear ethernet cfm peer meps {all| domain domain-name {all| service service-name {all| local mep-id id}}|
interface interface-name {all| domain domain-name}}
Clears counters for all peer MEPs.all
String of a maximum of 80 characters that identifies
the domain in which the maintenance points reside.
For more information about the syntax, use
the question mark (?) online help function.
Note
domain domain-name
String of a maximum of 80 characters that identifies
the maintenance association to which the maintenance
end points belong.
service service-name
Local maintenance end point (MEP) ID number. The
range for MEP ID numbers is 1 to 8191.
local mep-id id
String of a maximum of 80 characters that identifies
the Ethernet interface.
interface interface-name
Command Default
No default behavior or values
Command Modes
EXEC (#)
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
This command removes all received CCMs and corresponding peer MEPs from the database (other than those
configured with cross-check). The peer MEPs will be added again when the next CCM is received.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
171
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
clear ethernet cfm peer meps
To Next Page
Loading...
Need help?
General
