maximum-meps
To configure the maximum number of maintenance end points (MEPs) for a service, use the maximum-meps
command in CFM domain service configuration mode. To return to the default value, use the no form of this
command.
maximum-meps number
Syntax Description
Maximum number of MEPs allowed for this service. The range is 2 to 8190.
number
Command Default
The default is 100.
Command Modes
CFM domain service configuration (config-cfm-dmn-svc)
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
This command configures the maximum number of peer maintenance end points (MEPs). It does not limit
the number of local MEPs. The configured maximum-meps number must be at least as great as the number
of configured crosscheck MEPs.
The maximum-meps number limits the number of peer MEPs, for which local MEPs store continuity-check
messages (CCMs). When the limit is reached, CCMs from any new peer MEPs are ignored, but CCMs from
existing peer MEPs continue to be processed normally.
The maximum-meps number also limits the size of the CCM learning database.
Task ID
OperationsTask ID
read, writeethernet-services
Examples
The following example shows how to configure the maximum number of maintenance end points (MEPs) for
a service:
RP/0/RSP0/CPU0:router# configure
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
274
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
maximum-meps
To Next Page
Loading...
Need help?
General
