threshold (SONET)
To set the bit error rate (BER) threshold values of the specified alarms for a SONET controller, use the
threshold command in SONET/SDH configuration mode. To remove the setting of the threshold from the
configuration file and restore the default condition, use the no form of this command.
threshold {b1-tca| b2-tca| sd-ber| sf-ber} bit-error-rate
no threshold {b1-tca| b2-tca| sd-ber| sf-ber} bit-error-rate
Syntax Description
Sets the B1 BER threshold crossing alarm (TCA). Range is from 3 through 9.
Default is 10e-6.
b1-tca
Sets the B2 BER threshold crossing alarm (TCA). Range is from 3 through 9.
Default is 10e-6.
b2-tca
Sets the signal degrade BER threshold. Range is from 3 through 9. Default is
10e-6.
sd-ber
Sets the signal failure BER threshold. Range is from 3 through 9. Default is
10e-3.
sf-ber
BER from 3 to 9 (10 to the minus x).
bit-error-rate
Command Default
b1-tca: 10e-6
b2-tca: 10e-6
sd-ber: 10e-6
sf-ber: 10e-3
Command Modes
SONET/SDH configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
923
SONET Controller Commands on the Cisco ASR 9000 Series Router
threshold (SONET)
To Next Page
Loading...
Need help?
General
