The flow-control command is supported on Gigabit Ethernet, TenGigE interfaces only; the flow-control
command is not supported on Management Ethernet Interfaces.
Note
The flow-control command syntax options may vary, depending on the type of PLIM or SPA that is
installed in your router.
Note
Task ID
OperationsTask ID
read, writeinterface
Examples
This example shows how to enable the sending of flow-control pause frames for ingress traffic on the TenGigE
interface 0/3/0/0:
RP/0/RSP0/CPU0:router(config)# interface TenGigE 0/3/0/0
RP/0/RSP0/CPU0:router(config-if)# flow-control ingress
Related Commands
DescriptionCommand
Displays statistics for all interfaces configured on the router or for
a specific node.
show interfaces, on page 516
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
84
Ethernet Interface Commands on the Cisco ASR 9000 Series Router
flow-control
To Next Page
Loading...
Need help?
General
