SONET Controller Commands on the
Cisco ASR 9000 Series Router
This module provides command line interface (CLI) commands for configuring SONET operation, using
Layer 1 SONET transport technology, on the Cisco ASR 9000 Series Router.
The configuration of the SONET controller includes SONET Automatic Protection Switch (APS), which is
a feature offering recovery from fiber (external) or equipment (interface and internal) failures at the SONET
line layer. You must configure a SONET controller before you can configure a Packet-over-SONET/SDH
(POS) interface or a serial interface.
All SONET-related configurations of a SONET-based physical port are grouped under the SONET controller
configuration submode. The SONET path-related configuration commands are grouped under the SONET
path submode.
•
ais-shut (SONET), page 835
•
ais-shut (SONET path), page 837
•
aps group, page 839
•
aps group (global), page 842
•
au, page 844
•
authenticate (PGP), page 846
•
b3-ber-prdi, page 848
•
channel local, page 849
•
channel remote, page 851
•
clear counters sonet, page 853
•
clock source (SONET), page 855
•
controller (SONET), page 857
•
delay clear, page 859
•
delay trigger, page 861
•
down-when-looped, page 863
•
framing (SONET), page 864
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
833
To Next Page
Loading...
Need help?
General
